--- The switch positions.
--- The faults page.
--- The device info page.
--- The maintenance page. The configuration parameters described below are set at this page.This page describes the device driver and the device window for the C&M Systems Microwave Waveguide Switching system controller: Model CM30510 with up to 2 waveguide switches but without any HPA or KPA redundancy.
Device window pages
The following table shows which device window pages are available with this individual device type.
--- The switch positions. --- The faults page. --- The device info page. --- The maintenance page. The configuration parameters described below are set at this page.Configuration parameters
At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the unit.
| parameter | description |
|---|---|
| address | The device address (decimal) as set at the device's front panel. |
| Serial | Remember to set the line parameters for the serial interface |
| readBackDelay | Defines the delay the driver uses when it reads back parameters recently commanded. The delay is initialized at a proved preset value which should not be changed under normal circumstances. |
Variables defined by this device driver
| name | type | flags | range |
|---|---|---|---|
| info.driver | TEXT | R/O | StringRange R/O |
| lowLevel.cmd | TEXT | StringRange | |
| lowLevel.reply | TEXT | R/O | StringRange R/O |
| faults.99 | ALARM | R/O | AlarmFlagRange R/O (Communication) |
| faults.commstat | TEXT | R/O | StringRange R/O |
| info.type | TEXT | R/O | StringRange R/O |
| info.port | TEXT | R/O | StringRange R/O |
| info.frame | TEXT | R/O | StringRange R/O |
| info.model | TEXT | R/O | StringRange R/O |
| info.revision | TEXT | R/O | StringRange R/O |
| config.readBackDelay | INTEGER | SAVE SETUP | IntegerRange (100 .. 10000) |
| reset | TEXT | NOPRESET | StringRange |
| switch.01 | CHOICE | EnumRange (A B FLT) | |
| switch.02 | CHOICE | EnumRange (A B FLT) | |
| faults.01 | ALARM | R/O | AlarmFlagRange R/O (Remote access) |
| faults.03 | ALARM | R/O | AlarmFlagRange R/O (PSU 1) |
| faults.04 | ALARM | R/O | AlarmFlagRange R/O (PSU 2) |
| faults.05 | ALARM | R/O | AlarmFlagRange R/O (AC1 5V) |
| faults.06 | ALARM | R/O | AlarmFlagRange R/O (AC2 5V) |
| faults.07 | ALARM | R/O | AlarmFlagRange R/O (AC1 30V) |
| faults.08 | ALARM | R/O | AlarmFlagRange R/O (AC2 30V) |
| faults.21 | ALARM | R/O | AlarmFlagRange R/O (Switch 1) |
| faults.22 | ALARM | R/O | AlarmFlagRange R/O (Switch 2) |