1.234 Evertz-7703-BPX

This page describes the device driver and the device window for the Evertz 7800 Chassis BPX type redundancy cards including the following supported cards:

• 7703BPX-LB,
• 7703BPXA-LB,
• 7703BPX50-LB,
• 7703BPXA-LB-50,
• 7703BPX-IF,
• 7703BPXA-IF,
• 7703BPX50-IF,
• 7703BPX-LB-DC,
• 7780BPX-DS3,
• 7703BPX-DC-RF

The driver was tested with the following cards:

• Model: 7703BPXA-IF
• SW: 1.2.5
• Model: 7703BPXA-LB
• SW: 1.2.5

Device window pages

The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .

• --- Shows the rf level and threshold of channel A and B and the redundancy parameters
• --- The faults page.
• --- The device info page.
• --- The maintenance page. The configuration parameters described below are set at this page.

Configuration parameters

At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the controller.

• parameter --- description

• address --- The SNMP address specification for the device. The full address specification consists of the following fields:aaa.bbb.ccc.ddd:pppp read-community write-community

  • aaa.bbb.ccc.ddd --- The IP address of the device in 'dotted quad' notation. This field is mandatory.
  • pppp --- The IP port number where the device accepts SNMP requests. The port number may be omitted, the driver uses the standard port 161 in this case.
  • read-community --- The SNMP read community name. This must match the read community expected by the device.
  • write-community --- The SNMP write community name. This must match the write community expected by the device. The write community name may be omitted, the driver uses the read community name for both, read and write in this case. If both community names are missing, the driver uses 'public' as a default for read and write community.

• operationMode --- Defines the switch behaviour. Has to be set initially as it not read from device.

  • SW-ONCE: Card switches only from channel A to B, Switching back has to be done manually.
  • SW-ALWAYS: Card switch also back to channel A when in respective fault condition.

• delay --- Defines the switching delay in ms

• debounce --- Defines the switch debounce in ms

• slot --- Defines the slot number where the card is installed. Setting this parameter is indispensable for correct communication

Variables defined by this device driver