1.368 Miteq-NSU

This page describes an addon device driver and the device window for the Miteq NSU* upconverter redundancy controller.

The driver works with the 1:1, 2:1 and N:1 variants of the device. It automatically recognizes the number of chains controlled by the device and grays out the parameters of all unused chains. This is done once after the driver establishes communication to the device.

Beside the redundancy switch control the driver controls a number of settings for each upconverter connected to the Miteq NSU.

Device window pages

The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .

• --- Contains the redundancy switching parameters and the parameters of the connected upconverters

Configuration parameters

At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the device.

• parameter --- description
• address --- The SNMP address specification for the device. The full address specification consists of the following fields:aaa.bbb.ccc.ddd:pppp read-community write-community
  • aaa.bbb.ccc.ddd --- The IP address of the device in 'dotted quad' notation. This field is mandatory.
  • pppp --- The IP port number where the device accepts SNMP requests. The port number may be omitted, the driver uses the standard port 161 in this case.
  • read-community --- The SNMP read community name. This must match the read community expected by the device.
  • write-community --- The SNMP write community name. This must match the write community expected by the device. The write community name may be omitted, the driver uses the read community name for both, read and write in this case. If both community names are missing, the driver uses 'public' as a default for read and write community.

Variables defined by this device driver