1.565 Polsat-ACTS

This page describes the monitoring only device driver and the device window for the Polsat implementation of an REST-API for it�s ACTS software system with up to three ACUs connected.

Device window pages

The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .

Configuration parameters

At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the system.

parameter description
address The ip device address as well as username and passsword required for authetification
ACU Select which of the three ACUs to be monitored by the device.

Variables defined by this device driver

name type flags range
info.driver TEXT R/O StringRange R/O
lowLevel.cmd TEXT StringRange
lowLevel.reply TEXT R/O StringRange R/O
faults.99 ALARM R/O AlarmFlagRange R/O (Communication)
faults.commstat TEXT R/O StringRange R/O
info.type TEXT R/O StringRange R/O
info.port TEXT R/O StringRange R/O
info.frame TEXT R/O StringRange R/O
info.postResponse TEXT R/O StringRange R/O
info.name TEXT R/O StringRange R/O
info.temp INTEGER R/O IntegerRange R/O (0 .. 0)
config.acu CHOICE SAVE SETUP EnumRange (1 2 3)
config.deviceComment TEXT SAVE SETUP StringRange
state.az FLOAT R/O DoubleRange R/O (0.000 .. 0.000)
state.el FLOAT R/O DoubleRange R/O (0.000 .. 0.000)
state.pl FLOAT R/O DoubleRange R/O (0.00 .. 0.00)
state.mode1 TEXT R/O StringRange R/O
state.mode2 TEXT R/O StringRange R/O
state.target TEXT R/O StringRange R/O
faults.01 ALARM R/O AlarmFlagRange R/O (ODU)
faults.02 ALARM R/O AlarmFlagRange R/O (Beacon Rcv)
faults.03 ALARM R/O AlarmFlagRange R/O (Tracking)