1.547 RFDesign-FlexLink-S7Bc

This page describes the device driver and the device window for RF Design Combining L-Band Matrix S7Bc.

It supports up to 16 in and 8 outputs.
It was tested with SW: 3.1.A2.0.D1.1.S1.H1.1

Device window pages

The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .

• --- Select Crosspoints.
• --- Output state, alias names and configuration.
• --- Edit input alias names.
• --- The faults page.
• --- The device info page.
• --- The maintenance page.

Configuration parameters

At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the device.

• parameter --- description
• address --- The SNMP address specification for the device. The full address specification consists of the following fields:aaa.bbb.ccc.ddd:pppp read-community write-community
  • aaa.bbb.ccc.ddd --- The IP address of the device in 'dotted quad' notation. This field is mandatory.
  • pppp --- The IP port number where the device accepts SNMP requests. The port number may be omitted, the driver uses the standard port 161 in this case.
  • read-community --- The SNMP read community name. This must match the read community expected by the device.
  • write-community --- The SNMP write community name. This must match the write community expected by the device. The write community name may be omitted, the driver uses the read community name for both, read and write in this case. If both community names are missing, the driver uses 'public' as a default for read and write community.
• readBackDelay --- Defines the delay the driver uses when it reads back parameters recently commanded. The delay is initialized at a proved preset value which should not be changed under normal circumstances.

Alias names

After changing the alias names of the input and or output channels from the device driver or Web interface it is necessary to use the read alias names from chassis button on the device driver. The reason is that reading these value is only done initially at server startup due to the slow device SNMP performance.

Variables defined by this device driver