--- Contains the redundancy switching parameters
--- Contains the LNA/LNB meter readings (not applicable with this device).This page describes the device driver and the device window for the Satellink-1to2-Redundant-LNA controller.
The sat-nms M&C communicates with this device through a built in Lantronix XPort IP to RS232 converter. The IP address of this device has to be set as the interface name in the sat-nms device setup, the factory default for the port number is 10001.
Device window pages
The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .
--- Contains the redundancy switching parameters --- Contains the LNA/LNB meter readings (not applicable with this device).Configuration parameters
There are no special configuration parameters for this device.
Variables defined by this device driver
| name | type | flags | range |
|---|---|---|---|
| info.driver | TEXT | R/O | StringRange R/O |
| lowLevel.cmd | TEXT | StringRange | |
| lowLevel.reply | TEXT | R/O | StringRange R/O |
| faults.99 | ALARM | R/O | AlarmFlagRange R/O (Communication) |
| faults.commstat | TEXT | R/O | StringRange R/O |
| info.type | TEXT | R/O | StringRange R/O |
| info.port | TEXT | R/O | StringRange R/O |
| info.frame | TEXT | R/O | StringRange R/O |
| internal.p | TEXT | R/O | StringRange R/O |
| protection | CHOICE | EnumRange (MANUAL AUTO) | |
| position | CHOICE | EnumRange (3-STBY 1-STBY 2-STBY) | |
| position.1 | CHOICE | EnumRange (A B ?) | |
| position.2 | CHOICE | EnumRange (A B ?) | |
| faults.01 | ALARM | R/O | AlarmFlagRange R/O (Power supply 1) |
| faults.02 | ALARM | R/O | AlarmFlagRange R/O (Power supply 2) |
| faults.03 | ALARM | R/O | AlarmFlagRange R/O (Remote control) |
| faults.04 | ALARM | R/O | AlarmFlagRange R/O (Switch 1) |
| faults.05 | ALARM | R/O | AlarmFlagRange R/O (Switch 2) |
| faults.08 | ALARM | R/O | AlarmFlagRange R/O (Protection) |
| faults.11 | ALARM | R/O | AlarmFlagRange R/O (LNA/LNB1) |
| faults.12 | ALARM | R/O | AlarmFlagRange R/O (LNA/LNB2) |
| faults.13 | ALARM | R/O | AlarmFlagRange R/O (LNA/LNB3) |