1.677 Teledyne-QMultiFlex

This page describes the device driver and the device window for the Teledyne-QMuliFlex-400 device. It supports modem functionalities with RF rx and tx interface as well as four ethernet interfaces for traffic. For receiving, the modem utilises 16 separate demodulators. This driver only controls the RF functionalities of the modem. Source and destination IP addresses have to be set manually in the web based interface.

Known issues

When setting or changing the modulation or reloading a stored configuration, the device itself takes up to several seconds to process these changes and is unable. Communication faults that last a few seconds are expected when performing some changes due to the nature of the QMuliFlex-400 device.

Device window pages

The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .

• --- Lets the user set the mesh topology as well as TX/RX-frequencies and power.
• --- Contains the parameters for the TX modulator such as data-/symbolrate, modulation, fec etc.
• --- Contains similar parameters but for demodulation and dusplayes power values, lock status and RF receive status e.g. eb/n0 or power level.
• --- Displays the current bit- and datarate, dropped packets and error packets for tx and each of the 16 rx channels.
• --- Enables the saving and recalling internally stored device configurations.
• --- The faults page.
• --- The device info page.
• --- The maintenance page. The configuration parameters described below are set at this page.

Configuration parameters

At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the unit.

• parameter --- description

• address --- The SNMP address specification for the device. The full address specification consists of the following fields:aaa.bbb.ccc.ddd:pppp read-community write-community

  • aaa.bbb.ccc.ddd --- The IP address of the device in 'dotted quad' notation. This field is mandatory.
  • pppp --- The IP port number where the device accepts SNMP requests. The port number may be omitted, the driver uses the standard port 161 in this case.
  • read-community --- The SNMP read community name. This must match the read community expected by the device.
  • write-community --- The SNMP write community name. This must match the write community expected by the device. The write community name may be omitted, the driver uses the read community name for both, read and write in this case. If both community names are missing, the driver uses 'public' as a default for read and write community.

• readBackDelay --- Defines the delay the driver uses when it reads back parameters recently commanded. The delay is initialized at a proved preset value which should not be changed under normal circumstances.

• pupPassword --- The password for using PUP Commands is to be set here as a string. The internal PUP Command "console" is used by the driver to save configurations in the device internally, delete them or acces them to be applicated.

Variables defined by this device driver