--- The operational parametersThis page describes the device driver and the device window for the Work Microwave RSC 1:1 Redundancy Switch
Device window pages
The following table shows which device window pages are available with this individual device type.
--- The operational parametersConfiguration parameters
At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the unit.
Variables defined by this device driver
| name | type | flags | range |
|---|---|---|---|
| info.driver | TEXT | R/O | StringRange R/O |
| lowLevel.cmd | TEXT | StringRange | |
| lowLevel.reply | TEXT | R/O | StringRange R/O |
| faults.99 | ALARM | R/O | AlarmFlagRange R/O (Communication) |
| faults.commstat | TEXT | R/O | StringRange R/O |
| info.type | TEXT | R/O | StringRange R/O |
| info.port | TEXT | R/O | StringRange R/O |
| info.frame | TEXT | R/O | StringRange R/O |
| info.serial | TEXT | R/O | StringRange R/O |
| info.revision | TEXT | R/O | StringRange R/O |
| config.readBackDelay | INTEGER | SAVE SETUP | IntegerRange (100 .. 10000) |
| config.operationMode | CHOICE | SETUP | EnumRange (one time auto reactivation priority A priority B) |
| protection | CHOICE | EnumRange (OFF ON TEMP-OFF) | |
| recovDelay | INTEGER | IntegerRange (0 .. 65535) | |
| location | CHOICE | EnumRange (1 2) | |
| position | CHOICE | EnumRange (A B) | |
| faults.01 | ALARM | R/O | AlarmFlagRange R/O (Remote access) |
| faults.02 | ALARM | R/O | AlarmFlagRange R/O (PSU1) |
| faults.03 | ALARM | R/O | AlarmFlagRange R/O (PSU2) |
| faults.04 | ALARM | R/O | AlarmFlagRange R/O (Relays 1) |
| faults.05 | ALARM | R/O | AlarmFlagRange R/O (Relays 2) |
| faults.06 | ALARM | R/O | AlarmFlagRange R/O (Indicator supply shortage) |
| faults.08 | ALARM | R/O | AlarmFlagRange R/O (Protection) |
| faults.11 | ALARM | R/O | AlarmFlagRange R/O (UNIT A) |
| faults.12 | ALARM | R/O | AlarmFlagRange R/O (UNIT B) |