9.79 Blankom-DRP393-SNMP

This page describes the device driver and the device window for the Blankom DRP-393 IRD, controlled via SNMP.

Device window pages

The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .

• --- Contains the main receiver settings and status display.
• --- Contains MPTS transport stream output parameters (ASI and IP)
• --- Contains the parameters concerning the video decoding and SDI output.
• --- Contains the parameters concerning the audio outputs and the selection of the audio signals from the MPEG stream.
• --- The faults page.
• --- The device info page.
• --- The maintenance page. The configuration parameters described below are set at this page.

Configuration parameters

At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the DRP-393.

• parameter --- description

• address --- The SNMP address specification for the device. The full address specification consists of the following fields:aaa.bbb.ccc.ddd:pppp read-community write-community

  • aaa.bbb.ccc.ddd --- The IP address of the device in 'dotted quad' notation. This field is mandatory.
  • pppp --- The IP port number where the device accepts SNMP requests. The port number may be omitted, the driver uses the standard port 161 in this case.
  • read-community --- The SNMP read community name. This must match the read community expected by the device.
  • write-community --- The SNMP write community name. This must match the write community expected by the device. The write community name may be omitted, the driver uses the read community name for both, read and write in this case. If both community names are missing, the driver uses 'public' as a default for read and write community.

• 22kHz --- Makes the IRD apply a 22 kHz tone to the LNB power when set to ON.

• 22kHzAuto --- If set to ON, the driver switches the 22 kHz tone depending on the receive frequency. Frequencies above the 'bandEdge' value cause the 22kHz tone to be switched on, lower frequencies switch the tone off. The 22kHzAuto mode overwrites the the '22kHz' setting described above.

• lnbVoltage --- Selects the LNB power supply voltage (OFF/13V/18V). This switches the polarization (13V=Vertical) with some LNBs.

• lnbPolSwitch --- If you set this parameter to ON, the 'lnbVoltage' parameter above becomes read-only and the LNB voltage is controlled though the 'polarization' parameter of the device driver

• loFreqHigh --- The LO frequency for the high frequency band. The software sets the appropriate LO frequency every time before it changes the receive frequency.

• loFreqLow --- The LO frequency for the low frequency band. The software sets the appropriate LO frequency every time before it changes the receive frequency.

• bandEdge --- The frequency where the software switches the LO frequencies.

• marginThreshold --- Defines the minimum s/n margin value the driver accepts as OK. s/n margin values below this threshold raise an "Margin" fault (faults.30). The margin fault detection is done by the sat-nms device driver, not by the device itself. Hence, the margin value ist stored as a saved parameter on the VLC rather than as a parameter in the IRD.

• deviceComment --- An optional text entered here appears as an addition to the tooltip which is shown while the mouse is placed over a device icon in the GUI. The "\n" character sequence is translated into a newline character, splitting the text into multiple lines.

Variables defined by this device driver