9.108 Cisco-2800GSM-SNMP

This page describes the device driver and the device window for Cisco 2800 router with 3G/GSM card. It monitors only the 3G/GSM specific parameters. It is possible to combine an instance of this driver (device) with other MIB2 or Router drivers on the same interface with protocol type SNMP to get additional parameters.

Device window pages

The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .

• --- Displays the Main Receive Parameters
• --- The faults page.
• --- The device info page.
• --- The maintenance page. The configuration parameters described below are set at this page.

Configuration parameters

These are the driver configuration parameters of the Cisco-Router driver:

• parameter --- description

• address --- The SNMP address specification for the device. The full address specification consists of the following fields:aaa.bbb.ccc.ddd:pppp read-community write-community

  • aaa.bbb.ccc.ddd --- The IP address of the device in 'dotted quad' notation. This field is mandatory.
  • pppp --- The IP port number where the device accepts SNMP requests. The port number may be omitted, the driver uses the standard port 161 in this case.
  • read-community --- The SNMP read community name. This must match the read community expected by the device.
  • write-community --- The SNMP write community name. This must match the write community expected by the device. The write community name may be omitted, the driver uses the read community name for both, read and write in this case. If both community names are missing, the driver uses 'public' as a default for read and write community.

• radioInterfaceIdentifier --- interface number of 3G/GSM card

• rssiLowThreshhold --- alarm threshold for 3G/GSM signal

Variables defined by this device driver