--- The beacon receiver parameters.
--- The faults page.
--- The device info page.
--- The maintenance page. The configuration parameters described below are set at this page.This page describes the device driver and the device window for the for the GDSatcom Digital Tracking Receiver Model 520/550 using the GDsatcom-TRU protocol.
The default TCP/IP communication port is : 5060
Device window pages
The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .
--- The beacon receiver parameters. --- The faults page. --- The device info page. --- The maintenance page. The configuration parameters described below are set at this page.Configuration parameters
At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the unit.
| parameter | description |
|---|---|
| address | The Management IP address specification for the device followed by the TCP/IP Port. e.g.: 10.10.1.10:5060 |
| aliasPolA | Defines the polarization A. |
| aliasPolB | Defines the polarization B. |
| controlMode | Defines the control mode local or remote. |
| vcoMode | Defines the VCO mode automatic or manual. |
| vcoOffset | Defines the VCO offset in kHz. |
Variables defined by this device driver
| name | type | flags | range |
|---|---|---|---|
| info.driver | TEXT | R/O | StringRange R/O |
| lowLevel.cmd | TEXT | StringRange | |
| lowLevel.reply | TEXT | R/O | StringRange R/O |
| faults.99 | ALARM | R/O | AlarmFlagRange R/O (Communication) |
| faults.commstat | TEXT | R/O | StringRange R/O |
| info.type | TEXT | R/O | StringRange R/O |
| info.port | TEXT | R/O | StringRange R/O |
| info.frame | TEXT | R/O | StringRange R/O |
| info.swVersion | TEXT | R/O | StringRange R/O |
| info.swDate | TEXT | R/O | StringRange R/O |
| info.hwVersion | TEXT | R/O | StringRange R/O |
| info.fpgaVersion | TEXT | R/O | StringRange R/O |
| info.temperature | FLOAT | R/O | DoubleRange R/O (0.0 .. 0.0) |
| info.trackMode | CHOICE | EnumRange (AZ/EL/POL MONOPULSE AZ/EL MONOPULSE POL MONOPULSE STEPTRACK) | |
| config.aliasPolA | TEXT | SAVE SETUP | StringRange |
| config.aliasPolB | TEXT | SAVE SETUP | StringRange |
| config.controlMode | CHOICE | SETUP | EnumRange (LOCAL REMOTE) |
| config.vcoMode | CHOICE | SETUP | EnumRange (MANUAL AUTO) |
| config.vcoOffset | FLOAT | SETUP | DoubleRange (-99.9 .. 99.9) |
| config.model | CHOICE | SAVE SETUP | EnumRange (DTR520 DTR550) |
| power | FLOAT | R/O | DoubleRange R/O (0.000 .. 0.000) |
| relPower | FLOAT | R/O | DoubleRange R/O (0.000 .. 0.000) |
| rfMode | CHOICE | R/O | EnumRange R/O (DIGITAL ANALOG WIDEBAND DVB) |
| frequency | FLOAT | DoubleRange (890.000 .. 30000.000) | |
| attenuation | INTEGER | IntegerRange (0 .. 31) | |
| sweepWidth | INTEGER | IntegerRange (8 .. 500) | |
| polarization | CHOICE | EnumRange (A B) | |
| bandwidth | CHOICE | EnumRange (0 - NONE) | |
| beaconControl | CHOICE | EnumRange (CW 800HZBPSK) | |
| signalOffset | FLOAT | DoubleRange (-100.0 .. 200.0) | |
| reset | TEXT | NOPRESET | StringRange |
| internal.range | TEXT | R/O | StringRange R/O |
| internal.pol | CHOICE | R/O | EnumRange R/O (0 1) |
| internal.f1 | INTEGER | R/O | IntegerRange R/O (0 .. 0) |
| internal.f2 | INTEGER | R/O | IntegerRange R/O (0 .. 0) |
| internal.f3 | INTEGER | R/O | IntegerRange R/O (0 .. 0) |
| internal.f4 | INTEGER | R/O | IntegerRange R/O (0 .. 0) |
| internal.i | INTEGER | R/O | IntegerRange R/O (0 .. 0) |
| info.availBandwidth | TEXT | R/O | StringRange R/O |
| internal.bw1 | INTEGER | R/O | IntegerRange R/O (0 .. 1) |
| internal.bw2 | INTEGER | R/O | IntegerRange R/O (0 .. 1) |
| internal.bw3 | INTEGER | R/O | IntegerRange R/O (0 .. 1) |
| internal.bw4 | INTEGER | R/O | IntegerRange R/O (0 .. 1) |
| internal.bw5 | INTEGER | R/O | IntegerRange R/O (0 .. 1) |
| internal.bw6 | INTEGER | R/O | IntegerRange R/O (0 .. 1) |
| internal.bw7 | INTEGER | R/O | IntegerRange R/O (0 .. 1) |
| internal.bw8 | INTEGER | R/O | IntegerRange R/O (0 .. 1) |
| internal.bw1text | FLOAT | R/O | DoubleRange R/O (0.0 .. 0.0) |
| internal.bw2text | FLOAT | R/O | DoubleRange R/O (0.0 .. 0.0) |
| internal.bw3text | FLOAT | R/O | DoubleRange R/O (0.0 .. 0.0) |
| internal.bw4text | FLOAT | R/O | DoubleRange R/O (0.0 .. 0.0) |
| internal.bw5text | FLOAT | R/O | DoubleRange R/O (0.0 .. 0.0) |
| internal.bw6text | FLOAT | R/O | DoubleRange R/O (0.0 .. 0.0) |
| internal.bw7text | FLOAT | R/O | DoubleRange R/O (0.0 .. 0.0) |
| internal.bw8text | FLOAT | R/O | DoubleRange R/O (0.0 .. 0.0) |
| internal.vcoMode | CHOICE | R/O | EnumRange R/O (MANUAL AUTO) |
| faults.01 | ALARM | R/O | AlarmFlagRange R/O (Remote access) |
| faults.02 | ALARM | R/O | AlarmFlagRange R/O (Summary Fault Active) |
| faults.03 | ALARM | R/O | AlarmFlagRange R/O (VCO Auto Control) |
| faults.04 | ALARM | R/O | AlarmFlagRange R/O (Track Fault Active) |
| faults.06 | ALARM | R/O | AlarmFlagRange R/O (Temperature Fault) |
| faults.07 | ALARM | R/O | AlarmFlagRange R/O (RF Synth. Unlocked) |
| faults.08 | ALARM | R/O | AlarmFlagRange R/O (IF Synth. Unlocked) |
| faults.09 | ALARM | R/O | AlarmFlagRange R/O (PLL Unlocked) |
| faults.10 | ALARM | R/O | AlarmFlagRange R/O (V1 Power Fault) |
| faults.11 | ALARM | R/O | AlarmFlagRange R/O (V2 Power Fault) |
| faults.12 | ALARM | R/O | AlarmFlagRange R/O (V3 Power Fault) |
| faults.13 | ALARM | R/O | AlarmFlagRange R/O (RCVR Synth. Unlocked) |
| faults.40 | ALARM | R/O | AlarmFlagRange R/O (Track Mode) |