9.413 NDSatCom-ACU6030-REST

This page describes the REST-HTTP based device driver and the device window for the ND SatCom antenna control unit ACU6030. It provides exaclty the same scope of functions as the older (terminal protocol based) version of the driver.

Device window pages

The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .

Configuration parameters

At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the antenna controller.

parameter description
address Enter the ACU's IP address here, including the pport nummber if this has to set to a non-standard value. Example: 10.10.0.1:9876

Variables defined by this device driver

name type flags range
info.driver TEXT R/O StringRange R/O
lowLevel.cmd TEXT StringRange
lowLevel.reply TEXT R/O StringRange R/O
faults.99 ALARM R/O AlarmFlagRange R/O (Communication)
faults.commstat TEXT R/O StringRange R/O
info.type TEXT R/O StringRange R/O
info.port TEXT R/O StringRange R/O
info.frame TEXT R/O StringRange R/O
info.version TEXT R/O StringRange R/O
info.temperature INTEGER R/O IntegerRange R/O (0 .. 0)
internal.x BOOLEAN R/O BooleanRange R/O (true false)
internal.y BOOLEAN R/O BooleanRange R/O (true false)
internal.z BOOLEAN R/O BooleanRange R/O (true false)
config.acuDeviceIndex INTEGER SAVE SETUP IntegerRange (0 .. 0)
azimuth FLOAT DoubleRange (0.0000 .. 0.0000)
elevation FLOAT DoubleRange (0.0000 .. 0.0000)
polarization FLOAT DoubleRange (0.0000 .. 0.0000)
frequency FLOAT R/O DoubleRange R/O (0.000 .. 0.000)
trackMode INTEGER NOPRESET IntegerRange (0 .. 0)
satellite CHOICE NOPRESET EnumRange (UNKNOWN)
satname TEXT R/O StringRange R/O
state.az FLOAT R/O DoubleRange R/O (0.0000 .. 0.0000)
state.el FLOAT R/O DoubleRange R/O (0.0000 .. 0.0000)
state.pl FLOAT R/O DoubleRange R/O (0.0000 .. 0.0000)
state.mode1 TEXT R/O StringRange R/O
state.mode2 TEXT R/O StringRange R/O
state.beacon FLOAT R/O DoubleRange R/O (0.00 .. 0.00)
state.moving BOOLEAN R/O BooleanRange R/O (true false)
state.limit BOOLEAN R/O BooleanRange R/O (true false)
reset TEXT NOPRESET StringRange
updateSatList TEXT NOPRESET StringRange
edit.satellite CHOICE EnumRange (UNKNOWN)
edit.name TEXT R/O StringRange R/O
edit.satNum TEXT R/O StringRange R/O
edit.orbit FLOAT R/O DoubleRange R/O (0.000 .. 0.000)
edit.azimuth FLOAT R/O DoubleRange R/O (0.000 .. 0.000)
edit.elevation FLOAT R/O DoubleRange R/O (0.000 .. 0.000)
edit.polarization FLOAT R/O DoubleRange R/O (0.000 .. 0.000)
edit.bfreq FLOAT R/O DoubleRange R/O (0.000 .. 0.000)
edit.bpol TEXT R/O StringRange R/O
edit.goto TEXT NOPRESET StringRange
ai INTEGER R/O IntegerRange R/O (0 .. 0)
mGeneral TEXT R/O StringRange R/O
faults.01 ALARM R/O AlarmFlagRange R/O (AZ high limit)
faults.02 ALARM R/O AlarmFlagRange R/O (AZ low limit)
faults.03 ALARM R/O AlarmFlagRange R/O (EL high limit)
faults.04 ALARM R/O AlarmFlagRange R/O (EL low limit)
faults.05 ALARM R/O AlarmFlagRange R/O (PL high limit)
faults.06 ALARM R/O AlarmFlagRange R/O (PL low limit)
faults.07 ALARM R/O AlarmFlagRange R/O (Beacon receive)
faults.08 ALARM R/O AlarmFlagRange R/O (Remote control)
faults.09 ALARM R/O AlarmFlagRange R/O (Emergency Stop)
faults.10 ALARM R/O AlarmFlagRange R/O (AZ interlock)
faults.11 ALARM R/O AlarmFlagRange R/O (EL interlock)
faults.12 ALARM R/O AlarmFlagRange R/O (ODU communication)
faults.13 ALARM R/O AlarmFlagRange R/O (BCRX communication)
faults.14 ALARM R/O AlarmFlagRange R/O (Tracking)
faults.15 ALARM R/O AlarmFlagRange R/O (Peaking)