--- Switch position.
--- The faults page.
--- The device info page.
--- The maintenance page. The configuration parameters described below are set at this page.This page describes the device driver and the device window for a Novotronik 9x1 Switch GTS0752A.
Device window pages
The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .
--- Switch position. --- The faults page. --- The device info page. --- The maintenance page. The configuration parameters described below are set at this page.Configuration parameters
The GTS0752A do not need any configuration parameters except the settings for the serial interface
| parameter | description |
|---|---|
| Serial | Remember to set the line parameters for the serial interface connected to the device. The recommended line setting for the use with the sat-nms software is 9600,N,8,1 . |
| readBackDelay | Defines the delay the driver uses when it reads back parameters recently commanded. The delay is initialized at a proved preset value which should not be changed under normal circumstances. |
Remote Control
RS485/422 uses Novotronik-ASCII protocol
RS232 uses Novotronik protocol
TCP uses Terminal LF protocol
Variables defined by this device driver
| name | type | flags | range |
|---|---|---|---|
| info.driver | TEXT | R/O | StringRange R/O |
| lowLevel.cmd | TEXT | StringRange | |
| lowLevel.reply | TEXT | R/O | StringRange R/O |
| faults.99 | ALARM | R/O | AlarmFlagRange R/O (Communication) |
| faults.commstat | TEXT | R/O | StringRange R/O |
| info.type | TEXT | R/O | StringRange R/O |
| info.port | TEXT | R/O | StringRange R/O |
| info.frame | TEXT | R/O | StringRange R/O |
| position | CHOICE | EnumRange (0 1 2 3 4 5 6 7 8 9) | |
| position.01 | CHOICE | R/O | EnumRange R/O (A B) |
| position.02 | CHOICE | R/O | EnumRange R/O (A B) |
| position.03 | CHOICE | R/O | EnumRange R/O (A B) |
| position.04 | CHOICE | R/O | EnumRange R/O (A B) |
| position.05 | CHOICE | R/O | EnumRange R/O (A B) |
| position.06 | CHOICE | R/O | EnumRange R/O (A B) |
| position.07 | CHOICE | R/O | EnumRange R/O (A B) |
| position.08 | CHOICE | R/O | EnumRange R/O (A B) |
| position.09 | CHOICE | R/O | EnumRange R/O (A B) |
| reset | TEXT | NOPRESET | StringRange |
| faults.01 | ALARM | R/O | AlarmFlagRange R/O (Remote access) |
| faults.02 | ALARM | R/O | AlarmFlagRange R/O (Summary) |