9.518 Peak-Blockupconverter

This page describes the device driver and the device window for the for the Peak Blockupconverter Series via SNMP.

It supports 1+1 and 2+1 configurations.

The driver was tested with IBUH without redundancy and UPC SW: 4.55

Device window pages

The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .

• --- The operational parameters
• --- The faults page.
• --- The device info page.
• --- The maintenance page. The configuration parameters described below are set at this page.

Configuration parameters

At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the unit.

• parameter --- description

• address --- The SNMP address specification for the device. The full address specification consists of the following fields:aaa.bbb.ccc.ddd:pppp read-community write-community

  • aaa.bbb.ccc.ddd --- The IP address of the device in 'dotted quad' notation. This field is mandatory.
  • pppp --- The IP port number where the device accepts SNMP requests. The port number may be omitted, the driver uses the standard port 161 in this case.
  • read-community --- The SNMP read community name. This must match the read community expected by the device.
  • write-community --- The SNMP write community name. This must match the write community expected by the device. The write community name may be omitted, the driver uses the read community name for both, read and write in this case. If both community names are missing, the driver uses 'public' as a default for read and write community.

• readBackDelay --- Defines the delay the driver uses when it reads back parameters recently commanded. The delay is initialized at a proved preset value which should not be changed under normal circumstances.

• lowGain --- Allows to adjust the lower gain limit of the respective unit.

• highGain --- Allows to adjust the upper gain limit of the respective unit.

• powerDisplayMode --- Defines the display of gain or attenuation in the parameter section.

• priority --- Allows to adjust the priority unit in a redundant setup.

• hasRedundancy --- Define if unit is part of a redundant setup.

• hasUpc --- Define if unit is equipped with a UPC.

Variables defined by this device driver