--- The control parameters
--- The faults page.
--- The device info page.
--- The maintenance page. The configuration parameters described below are set at this page.This page describes the device driver and the device window for the Satellite Systems (SSC) L-Band beacon tracking receiver of series 3430 BTR-L . It uses the Terminal-CR-CR protocol.
Device window pages
The following table shows which device window pages are available with this individual device type.
--- The control parameters --- The faults page. --- The device info page. --- The maintenance page. The configuration parameters described below are set at this page.Configuration parameters
At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the controller.
| parameter | description |
|---|---|
| address | Device address for serial communication |
| Serial | Remember to set the line parameters for the serial interface (only if connected to serial port of beacon receiver and not to Ethernet) |
| readBackDelay | Defines the delay the driver uses when it reads back parameters recently commanded. The delay is initialized at a proved preset value which should not be changed under normal circumstances. |
Variables defined by this device driver
| name | type | flags | range |
|---|---|---|---|
| info.driver | TEXT | R/O | StringRange R/O |
| lowLevel.cmd | TEXT | StringRange | |
| lowLevel.reply | TEXT | R/O | StringRange R/O |
| faults.99 | ALARM | R/O | AlarmFlagRange R/O (Communication) |
| faults.commstat | TEXT | R/O | StringRange R/O |
| info.type | TEXT | R/O | StringRange R/O |
| info.port | TEXT | R/O | StringRange R/O |
| info.frame | TEXT | R/O | StringRange R/O |
| config.readBackDelay | INTEGER | SAVE SETUP | IntegerRange (100 .. 10000) |
| voltage | FLOAT | R/O | DoubleRange R/O (0.00 .. 0.00) |
| frequency | FLOAT | DoubleRange (930.00 .. 2300.00) | |
| reference | FLOAT | DoubleRange (-100.0 .. -40.0) | |
| internal.v | FLOAT | R/O | DoubleRange R/O (0.00 .. 0.00) |
| internal.f1 | INTEGER | R/O | IntegerRange R/O (0 .. 0) |
| internal.f2 | INTEGER | R/O | IntegerRange R/O (0 .. 0) |
| faults.01 | ALARM | R/O | AlarmFlagRange R/O (Lock alarm) |
| faults.02 | ALARM | R/O | AlarmFlagRange R/O (Remote Access) |