9.610 SatService-LFRXTX

This page describes the device driver and the device window for the SatService L-Band Optical Links LFRX/TX. The drivers supports all configurations of the LFRX/TX chassis: Single, Master or Slave. But if the unit type changes it requires restarting of the M&C service, because the unit type is only read one time at startup.

Device window pages

The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .

• --- Master unit page
• --- Slave unit page
• --- Redundancy switching
• --- The faults page.
• --- The device info page.
• --- The maintenance page. The configuration parameters described below are set at this page.

Configuration parameters

The SatService LFRX/TX units do not need any configuration parameters except the settings for the SNMP interface

• parameter --- description
• address --- The SNMP address specification for the device. The full address specification consists of the following fields:aaa.bbb.ccc.ddd:pppp read-community write-community
  • aaa.bbb.ccc.ddd --- The IP address of the device in 'dotted quad' notation. This field is mandatory.
  • pppp --- The IP port number where the device accepts SNMP requests. The port number may be omitted, the driver uses the standard port 161 in this case.
  • read-community --- The SNMP read community name. This must match the read community expected by the device.
  • write-community --- The SNMP write community name. This must match the write community expected by the device. The write community name may be omitted, the driver uses the read community name for both, read and write in this case. If both community names are missing, the driver uses 'public' as a default for read and write community.

Variables defined by this device driver