2.1 Safety Instructions

Failure to observe all Warnings and Cautions may result in personnel injury and/or equipment damage not covered by the warranty.

• The equipment described in this manual is designed to be installed and used by properly trained personnel only!
• Follow standard Electrostatic Discharge (ESD) procedures when handling a sat-nms IO-FEP2.
• Select and apply the appropriate 24V D/C voltage according to the data sheet and documentation before connecting power.
• The sat-nms IO-FEP2 can be damaged if the input voltage is higher than the specified maximum value. Take care that ratings are not exceeded.
• The DIN Rail, on which your sat-nms IO-FEP2 is installed, has to be permanently connected to a grounding point for save operation. Otherwise, the device could be damaged. Furthermore it might be possible not to meet all of the mentioned EMC requirements.
• Install suitable over-voltage protection to ensure that no over-voltage (such as that caused by a bolt of lightning) or over-current can reach the product. Otherwise, the person operating the product will be exposed to the danger of an electric shock.
• Before connecting sat-nms IO-FEP2 to another unit, please make sure that the connected unit can handle the voltage provided by the sat-nms IO-FEP2.
• Before connecting the sat-nms IO-PEP2's output and input circuits, observe the maximum ratings mentioned on the datasheet. Exceeding these limits might damage your sat-nms IO-FEP2.
• Do not connect units that can be damaged by the output voltage of the sat-nms IO-FEP2.
• In case of a failure do not open the device, you will loose warranty, call SatService GmbH for an RMA number.
• Observe normal safety precautions when operating, servicing, and troubleshooting this equipment.
• Take standard safety precautions with hand and/or power tools.