Registers in this block control general setup parameters of the IO-FEP2. They are stored in the SETUP.TXT file on sd-card. Most of the parameters are character strings which must be 0-terminated.
Unused IP address parameters (e.g. for NTP or trap destinations) must be set to '0.0.0.0'. The same value the IO-FEP2 assigns if an IP address string cannot be parsed.
Register Purpose Remarks
00201 IP address
00211 netmask
00221 gateway
00231 user password hashed, not readable
00241 admin password hashed, not readable
00251 ntp server 1 IP
00261 ntp server 2 IP
00271 snmp read community
00281 snmp write community
00291 snmp trap community
00301 trap destination ip 1
00311 trap destination ip 2
00321 trap destination ip 3
00331 trap destination ip 4
00341 snmp location string
00351 snmp contact string
00361 web gui title string
00376 ntp time offset minutes, added to UTC to
achieve local time
00377 web gui refresh seconds
00378 RS232 remote address 65 ('A') .. 71 ('G') = Miteq
style protocol address
78 ('N') = No address, plain
text protocol
00379 number of parallel 0 = no limitation
switch actuations 1 .. 16 number of switch
actuations that may be active
concurrently
00380 psu alarm enable 1 enables alarms for the
redundant psu
00381 point & click 1 enables point & click
operation at the main page