2.6 Configuring the Optical Links

This chapter gives a short overview about some configuration parameters you want to set after you have installed the sat-nms LFTXRX. A complete reference of all available setup parameters is given in chapter Setup Parameters .

Setup / Config Parameter

The following settings have to be done or verify before the unit is connected to the network and to the RF interface:

• Set in the 'Setup' menu the Date/ Time und the Note to a specific Unit Name
• In the 'Config' menu define the 'Card Type' which is installed in each slot.
• Check the LNB-DC Setting to avoid external unit damages.
• If a switch card installed define the corrosponding connected slot card at No. Card Pas A and B. Make sure that the RF-interconnection is done in the same way.
• Set the Display calibration values 'RF Offset' and 'Diode RFOffset' for the RX and TX cards (seeTestreport of the card).

Please refer to Theory of operation for more detailed information about the Protection Mode configuration.