If a LFSW card is installed, you can read the following parameters:
| Parameter Name | Description |
|---|---|
| Remote | It is possible to change some settings of the LFTX card remote (e.g. via web browser interface) or local (only on the front panel of the card). The current state of the hardware remote/local switch on the corresponding card is shown here. |
| Protection | This parameter shows if the protection is active (ON) or (OFF). If the protection is ON, the card will switchover to the standby card if a fault occurs in the active card. |
| Switch Position | The switch postion displayes the actual position setting A or B path. |
| No. Card Pos A | Display the Slot number of switch position A. This is a 'Config Parameter' in the software but also the hardware interconnection from the switch connector A to the slot with the defined number have to be done. |
| No. Card Pos B | Display the Slot number of switch position B. This is a 'Config Parameter' in the software but also the hardware interconnection from the switch connector B to the slot with the defined number have to be done. |
| Protection State | The protection state displays, if a redundancy switching has been performed with a button labled 'switched'. By pressing the button the state can be reseted. |