2.1 Safety Instructions

Failure to observe all Warnings and Cautions may result in personnel injury and/or equipment damage not covered by the warranty.

• The equipment described in this manual is designed to be installed and used by properly trained personnel only!
• ATTENTION invisible Optical Radiation!If connected to a power supply, the unit provides invisible Laser-radiation. The source is class 3R Laser diode as defined in DIN EN 60825-1:2001-11. P0=2mW, Lambda=1310nm.
• Never look into fibre-optical components like connectors or fibres. Use an infrared viewer, optical power meter or fluorescent screen for optical output verification.
• Do not allow any dirt or foreign material to get into the optical connector bulkheads. This may cause damage to the polished optical connector end faces
• Follow standard Electrostatic Discharge (ESD) procedures when handling a the chassis and the modules of the LFTRX.
• Select and apply the appropriate 9…24DC voltage according to the data sheet and documentation before connecting power.
• Install suitable overvoltage protection to ensure that no overvoltage (such as that caused by a bolt of lightning) or overcurrent can reach the product. Otherwise, the person operating the product will be exposed to the danger of an electric shock.
• The LFTRX can be damaged if the total RF input power is higher than +10dBm specified maximum value. Do not connect equipment where the total output power is higher than the specified value of the data sheet or indicated on the LFTRX unit.
• In case of a failure do not open the sat-nms LFTRX, you will loose warranty, call SatService GmbH for a RMA number.
• Observe normal safety precautions when operating, servicing, and troubleshooting this equipment.
• Take standard safety precautions with hand and/or power tools.
• When connecting the units fault relay circuits, observe the maximum ratings: 24V D/C 50mA.