2.1 Safety Instructions

Failure to observe all Warnings and Cautions may result in personnel injury and/or equipment damage not covered by the warranty.

• Follow standard Electrostatic Discharge (ESD) procedures when handling an sat-nms RMC.
• Select and apply the appropriate 24V D/C voltage according to the data sheet before connecting power.
• Before connecting the sat-nms RMC to other devices, ensure that these devices can handle the voltage provided by sat-nms RMC.
• The sat-nms RMC can be damaged if the input voltage is higher than the specified maximum value.
• Don't connect a heater without the corresponding Temperature-Sensor. If you don't connect a Temperature-Sensor, the Temperature regulation in the sat-nms RMC is going to switch on the heater permanently until the regarding temperature-switch turn off the heater.
• Move an antenna only with connected end switches.
• In case of a failure do not open the sat-nms RMC enclosure, you will lose warranty. Call SatService GmbH for an RMA number.
• Observe normal safety precautions when operating, servicing, and troubleshooting this equipment.
• Take standard safety precautions with hand and/or power tools.