1.294 Hitec-AFP-ACU

This page describes the monitoring only device driver and the device window for the Hitec Antenna Front Panel. The driver covers the ACU related parameters

Device window pages

The following table shows which device window pages are available with this individual device type.

Configuration parameters

At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the unit.

parameter description
address The device address (decimal) as set at the device's front panel.

Variables defined by this device driver

name type flags range
info.driver TEXT R/O StringRange R/O
lowLevel.cmd TEXT StringRange
lowLevel.reply TEXT R/O StringRange R/O
faults.99 ALARM R/O AlarmFlagRange R/O (Communication)
faults.commstat TEXT R/O StringRange R/O
info.type TEXT R/O StringRange R/O
info.port TEXT R/O StringRange R/O
info.frame TEXT R/O StringRange R/O
config.readBackDelay INTEGER SAVE SETUP IntegerRange (100 .. 10000)
state.az FLOAT R/O DoubleRange R/O (0.000 .. 0.000)
state.el FLOAT R/O DoubleRange R/O (0.000 .. 0.000)
faults.01 ALARM R/O AlarmFlagRange R/O (Emergency stop)
faults.02 ALARM R/O AlarmFlagRange R/O (Driver Summary)
faults.03 ALARM R/O AlarmFlagRange R/O (General Summary)
faults.07 ALARM R/O AlarmFlagRange R/O (Access)
faults.08 ALARM R/O AlarmFlagRange R/O (Hardware Summary)
faults.09 ALARM R/O AlarmFlagRange R/O (Limit)