9.146 Comtech-UT4500-SNMP

This page describes the device driver and the device window for the Comtech upconverter series UT4500 with Ethernet interface and support for the internal 1+N redundancy.

The driver detects the model name and adapts the frequency range.

Device window pages

The following table shows which device window pages are available with this individual device type.

• --- The operational parameters
• --- The redundancy switching parameters

Configuration parameters

At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the Upconverter.

• parameter --- description
• address --- The SNMP address specification for the device. The full address specification consists of the following fields:aaa.bbb.ccc.ddd:pppp read-community write-community
  • aaa.bbb.ccc.ddd --- The IP address of the device in 'dotted quad' notation. This field is mandatory.
  • pppp --- The IP port number where the device accepts SNMP requests. The port number may be omitted, the driver uses the standard port 161 in this case.
  • read-community --- The SNMP read community name. This must match the read community expected by the device.
  • write-community --- The SNMP write community name. This must match the write community expected by the device. The write community name may be omitted, the driver uses the read community name for both, read and write in this case. If both community names are missing, the driver uses 'public' as a default for read and write community.

Variables defined by this device driver