9.306 Infratec-PM

This page describes the device driver and the device window for the Infratec Power Module IP Switch series and was tested with : PM4-IP (4 ports), PM4-IPS (4 ports), PM8-IP (8 ports), PM8-IPS (8 ports), PM-IP GOTO (8 port rackmount), PM821-IP (8 ports).

The driver detects automatically the connected switch model and adjusts the number of available ports/outlets.

Device window pages

The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .

• --- Shows and commands port status.
• --- The faults page.
• --- The device info page.
• --- The maintenance page. The configuration parameters described below are set at this page.

Configuration parameters

At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the device.

• parameter --- description

• address --- The SNMP address specification for the device. The full address specification consists of the following fields:aaa.bbb.ccc.ddd:pppp read-community write-community

  • aaa.bbb.ccc.ddd --- The IP address of the device in 'dotted quad' notation. This field is mandatory.
  • pppp --- The IP port number where the device accepts SNMP requests. The port number may be omitted, the driver uses the standard port 161 in this case.
  • read-community --- The SNMP read community name. This must match the read community expected by the device.
  • write-community --- The SNMP write community name. This must match the write community expected by the device. The write community name may be omitted, the driver uses the read community name for both, read and write in this case. If both community names are missing, the driver uses 'public' as a default for read and write community.

• retries --- The number of communication retries which are made at application level.

Variables defined by this device driver