--- The operational parameters
--- The faults page.
--- The device info page.
--- The maintenance page. The configuration parameters described below are set at this page.This page describes the device driver and the device window for the Paradise RCP2 redundancy controller. It was tested as a simple switch controller only.
Device window pages
The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .
--- The operational parameters --- The faults page. --- The device info page. --- The maintenance page. The configuration parameters described below are set at this page.Configuration parameters
At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the controller
| parameter | description |
|---|---|
| address | The device IP address and the SNMP community strings as set at the device's front panel. |
Communication protocol / Interface type
This device driver requires the SNMP protocol. Please remember to configure the ip settings and enable SNMP at the front panel
Variables defined by this device driver
| name | type | flags | range |
|---|---|---|---|
| info.driver | TEXT | R/O | StringRange R/O |
| lowLevel.cmd | TEXT | StringRange | |
| lowLevel.reply | TEXT | R/O | StringRange R/O |
| faults.99 | ALARM | R/O | AlarmFlagRange R/O (Communication) |
| faults.commstat | TEXT | R/O | StringRange R/O |
| info.type | TEXT | R/O | StringRange R/O |
| info.port | TEXT | R/O | StringRange R/O |
| info.frame | TEXT | R/O | StringRange R/O |
| info.serial | TEXT | R/O | StringRange R/O |
| info.model | TEXT | R/O | StringRange R/O |
| info.revision | TEXT | R/O | StringRange R/O |
| info.deviceType | TEXT | R/O | StringRange R/O |
| info.s1Position | TEXT | R/O | StringRange R/O |
| config.readBackDelay | INTEGER | SAVE SETUP | IntegerRange (100 .. 10000) |
| position | CHOICE | EnumRange (A B) | |
| location | CHOICE | EnumRange (1 2) | |
| protection | CHOICE | SAVE | EnumRange (AUTO MANUAL) |
| internal.s1 | INTEGER | R/O | IntegerRange R/O (0 .. 0) |
| faults.01 | ALARM | R/O | AlarmFlagRange R/O (Summary) |
| faults.02 | ALARM | R/O | AlarmFlagRange R/O (Power supply 1) |
| faults.03 | ALARM | R/O | AlarmFlagRange R/O (Power supply 2) |
| faults.04 | ALARM | R/O | AlarmFlagRange R/O (RF Switch 1) |
| faults.11 | ALARM | R/O | AlarmFlagRange R/O (Unit 1) |
| faults.12 | ALARM | R/O | AlarmFlagRange R/O (Unit 2) |