--- The operational parameters
--- The faults page.
--- The device info page.
--- The maintenance page. The configuration parameters described below are set at this page.This page describes the device driver and the device window for the Paradise RCP2 redundancy controller with serial interface Tested with a RCP2 unit which handles online one WG-Switch and no redundancy
Device window pages
The following table shows which device window pages are available with this individual device type. Tool-bar functions not mentioned here are described at the general description of device windows .
--- The operational parameters --- The faults page. --- The device info page. --- The maintenance page. The configuration parameters described below are set at this page.Configuration parameters
At the maintenance page of the device window there are a couple of configuration parameters which must be set to make the software talk to the unit
| parameter | description |
|---|---|
| address | Address of the unit |
Variables defined by this device driver
| name | type | flags | range |
|---|---|---|---|
| info.driver | TEXT | R/O | StringRange R/O |
| lowLevel.cmd | TEXT | StringRange | |
| lowLevel.reply | TEXT | R/O | StringRange R/O |
| faults.99 | ALARM | R/O | AlarmFlagRange R/O (Communication) |
| faults.commstat | TEXT | R/O | StringRange R/O |
| info.type | TEXT | R/O | StringRange R/O |
| info.port | TEXT | R/O | StringRange R/O |
| info.frame | TEXT | R/O | StringRange R/O |
| info.deviceType | TEXT | R/O | StringRange R/O |
| config.readBackDelay | INTEGER | SAVE SETUP | IntegerRange (100 .. 10000) |
| meas.current.1 | INTEGER | R/O | IntegerRange R/O (0 .. 0) |
| meas.current.2 | INTEGER | R/O | IntegerRange R/O (0 .. 0) |
| meas.current.3 | INTEGER | R/O | IntegerRange R/O (0 .. 0) |
| meas.voltage.1 | FLOAT | R/O | DoubleRange R/O (0.0 .. 0.0) |
| meas.voltage.2 | FLOAT | R/O | DoubleRange R/O (0.0 .. 0.0) |
| protection | CHOICE | EnumRange (MANUAL AUTO) | |
| priority | CHOICE | EnumRange (POL1 POL2) | |
| position | CHOICE | EnumRange (3-STBY 1-STBY 2-STBY) | |
| position.1 | CHOICE | EnumRange (A B) | |
| position.2 | CHOICE | EnumRange (A B) | |
| faults.01 | ALARM | R/O | AlarmFlagRange R/O (Remote access) |
| faults.02 | ALARM | R/O | AlarmFlagRange R/O (Summary) |
| faults.03 | ALARM | R/O | AlarmFlagRange R/O (Power supply 1) |
| faults.04 | ALARM | R/O | AlarmFlagRange R/O (Power supply 2) |
| faults.05 | ALARM | R/O | AlarmFlagRange R/O (Auxiliary) |
| faults.11 | ALARM | R/O | AlarmFlagRange R/O (LNA/LNB1) |
| faults.12 | ALARM | R/O | AlarmFlagRange R/O (LNA/LNB2) |
| faults.13 | ALARM | R/O | AlarmFlagRange R/O (LNA/LNB3) |