3.9 State All

Output Circuits

The table columns 1...2 shows the current state of all outputs which are configured to work as operator controlled outputs. The following applies to all output states:

• The displayed state ON/OFF is the logical state of the output. By default ON stands for a closed contact, however, each individual output may be configured to the inverse function at the Setup / Output Circuits page.
• Outputs configured as 'UNUSED' show neither a circuit name nor an ON/OFF state.
• Outputs configured to act as DEICE-Controller circuits are displayed with a dimmed name, without a circuit state.

Input Circuits

The table columns 3...5 show the state of the input circuits provided by the DEICE-Controller.

• Inputs configured as 'INPUT' show the states ON or OFF.
• Inputs configured as 'ALARM' show the states OK or FLT.
• Rows referring to 'UNUSED' inputs are left empty.
• The displayed state is the logical state of each input. By default ON/FLT stands for a closed contact, however, each individual input may be configured to the inverse function at the Setup / Input Circuits page.
• The displayed state also takes into account the delay time configured for each individual input. (This probably will not be visible for short delay times)

Temperature Readings

The DEICE-Controller displays the internal temperature and the reading of up to four external temperature sensors at the table field below the output circuits. For each sensor the sensor name, the temperature and an OK/FLT state is shown. A temperature value is considered 'OK' if the value is inside the limits configured at the Temperature Sensors page.