The page 'Settings' provides a 2-column table which is used to operate output circuits of the IO-FEP and the waveguide switch connected to it. Like the State page, the table shows the actual position of the outputs / switches. The display isn't updated automatically, so the displayed state may be outdated if the page is left open.
Clicking to the state of an output / waveguide switch opens a dialog which provides buttons to change the switch position. This dialog is password protected, you are required to login in order to change the position of waveguide switches or output circuits.
Protection switch parameters are shown in the third table column. Each protection switch may be set to ENABLED or DISABLED. ENABLED means that protection switch is 'hot', it will switch if a fault happens in the actually selected signal chain. The protection switch may be temporarely DISABLED, e.g. to perform maintenance tasks at the equipment without triggering the protection switch. For 2:1 protection switches the enabled state is coupled for both chains.
The function RESET resets the SWITCHED flag of the protection switch (only available if the SWITCHED flag of the particular protection switch is set).
2:1 protection switches show their loaction setting at the rightmost column. Clicking this lets you set the redundant chain use explicitely to NONE, CHAIN-1 or CHAIN-2. Note, that while enabled, the 2:1 protection switch does not allow to activate a chain if there is an error pending on it.
Please note: The 'Settings' page isn't updated automatically, so the displayed state may be outdated if the page is left open. Don't use your browser's 'reload' button to update the page as this will re-execute your last command with some bowsers. Instead, use the 'REFRESH PAGE' link below the table.