sat-nms IO-FEP User Manual

Version 3.0.006 -- 2021-07-29 -- © 2007-2021 SatService GmbH

Abstract

The IO-FEP manufactured by SatService GmbH is a frontend-processor which is especially designed for satellite ground stations. It allows to supervise potential-free (alarm-) contacts, to switch external items, to measure different temperatures, to switch and control waveguide- or coaxial-switches. It is possible to assign the inhibit-contacts of the waveguide-switches to up to 10 connected HPAs and additionally it is possible to realize different 1 to n redundancy systems.

This document describes how to install, setup and operate this antenna controller.

Table Of Contents

• 1 Introduction
• 2 Installation
  • 2.1 Safety Instructions
  • 2.2 Setting the IP Address
  • 2.3 Connecting the IO-FEP
  • 2.4 Configuring the SAT-NMS IO-FEP
  • 2.5 Mechanical installation
• 3 Operation
  • 3.1 The Web-based User Interface
  • 3.2 Displayed State
  • 3.3 Output Circuit / WG Switch Operation
  • 3.4 Installation Parameters
  • 3.5 General Setup
  • 3.6 Output Circuits
  • 3.7 WG Switches
  • 3.8 Input Circuits
  • 3.9 Temperature Sensors
  • 3.10 Protection
  • 3.11 Event Log
• 4 Remote Control
  • 4.1 General command syntax
  • 4.2 The TCP/IP remote control interface
  • 4.3 The RS232 remote control interface
  • 4.4 SNMP Control
  • 4.5 Parameter list
• 5 Connector Reference
• 6 Specifications