This chapter describes how to install the sat-nms LBRX beacon receiver. You find a guide how to connect, configure and mechanically mount the receiver below.
Before you start, please first read the Safety Instructions chapter below. It contains some important recommendations to prevent damage from the receiver.
Then, we strongly recommend to do a first setup of the receiver on a lab desk before installing it at it's final location. This is mainly for this reason:
The receiver may be configured to inject a 14/18V power supply voltage at it's RF input. If you plan to connect the receiver to a signal source which is not able to accept this D/C voltage, you must ensure that the voltage is switched off before you connect the receiver to that signal source.
Hence, the typical sequence of tasks when putting an sat-nms LBRX beacon receiver into operation is as follows: