After entering the IP-address to the browser the local chassis parameter will be displayed. With pressing the Master Ch. button, all the parameters of the master chassis are displayed. On the top of the page, you can read the name of the unit, that can be set on the 'Setup' page. Also you can see the state of the 2 power supplies and the frame temperature.
With pressing the Slave Ch. button, all the parameters of the slave chassis are displayed in the same way as for the master.
If the communication broke down, you can only see the parameters of the unit on which website you are on. For example the unit on which website you are on is configured as a slave, you can only see the values by pressing the Slave Ch button and on the Master Ch. page only only a communication fault is displayed.
If the sat-nms LFTX/RX is configured as 'single' unit, the parameters of this unit are displayed anyway on both pages.
Underneath all the measured parameters of the LFTX or LFRX cards are displayed for every slot. In the first line of every slot-field, you can read the number of the slot whether a LFRX-, a LFTX- or no card is placed to the corresponding slot and the name of this slot. The Name of every slot can be changed in the 'Config' menu. On the right side of every slot field you can see the summary state of the corresponding slot. The following states can be displayed:
| Parameter Name | Description |
|---|---|
| OK (green) | All parameters are within the given range, everything is ok. |
| FLT (red) | One or more parameters is out of range, fault state. |
| STBY (black) | (Only slot 3 and/or 8) If slot 3 or slot 8 is configured as a redundancy slot, STBY (standby) is displayed when the placed card(s) are in wait-state. |