2.1 Safety Instructions

Failure to observe all Warnings and Cautions listed below may result in personnel injury and/or equipment damage not covered by the warranty.

• Follow standard Electrostatic Discharge (ESD) procedures when handling an Power Sensor Unit.
• Select and apply the appropriate 24V DC voltage according to the data sheet and documentation before connecting power.
• The PowerSensor will be damaged if the total RF input power is higher then +20dBm. Do not connect the RF input of the Power Sensor to interfaces where the total output power is higher than the specified value of the data sheet or indicated on the PowerSensor.
• In case of an failure don't open the Power Sensor, call SatService GmbH for an RMA number.
• Observe normal safety precautions when operating, servicing, and troubleshooting this equipment.
• Take standard safety precautions with hand and/or power tools.
• When connecting the PowerSensor's fault relay circuit, observe the maximum ratings: 120V D/C, 100 mA. The fault circuit is a Photo MOS semiconductor relay which will immediately damaged when connected to higher voltages than specified.