The table below shows the complete list of M&C parameters the power sensor knows. For each parameter the data type and a short description is given.
| name | type | unit | description | |
|---|---|---|---|---|
| dbms | r/o | float | dBm | The calibrated / temperature compensated power reading in dBm. See chapter Power Reading power reading for a detailed description. |
| adcv | r/o | int | The raw ADC value without any calibration or compensation applied. The value is in the range 0 .. 65535. | |
| temp | r/o | float | °C | The temperature measured inside the power sensor enclosure. The value is in degree Celsius. |
| sens | r/o | LOW HIGH | The actual input amplifier sensivity. sens is either HIGH or LOW | |
| tflt | r/o | FAULT OK | The threshold fault state. if the power reading is below the threshold the value is FAULT else OK | |
| tsya | r/o | NTP time sync alarm | ||
| smod | AUTO LOW HIGH | Sets the sensivity range, the power sensor uses. See chapter Operational Settings Sensor Sensitivity for a detailed description. | ||
| fltr | OFF FAST SLOW | Sets the filter, the power sensor applies to the measured values. See chapter Operational Settings Average Filter for a detailed description. | ||
| thrh | float | dBm | Defines the alarm threshold value. See chapter Operational Settings Alarm threshold for a detailed description. | |
| freq | int | MHz | Defines the frequency of the measured signal in MHz. See chapter Operational Settings RF frequency for a detailed description. | |
| fcor | r/o | float | dB | The calibration offset, the power sensor actually adds to each measured value due to the frequency response calibration. See chapter Power Reading cal offest freq for a detailed description. |
| offs | float | dB | The value [dB] specified with this parameter is added to the measured power before it is displayed and compared to the fault threshold value. See chapter Operational Settings Display Offset for a detailed description. | |
| srno | r/o | character string | The power sensor's serial number. This is a five digit hexadecimal number which uniquely identifies each individual unit. For the one line command use ' snr' instead 'srno'. | |
| note | character string | The Power Sensor Note / comment, which is displayed by the power sensor as the heading of the 'Readings' page. | ||
| udpa | character string | UDP destination address | ||
| sver | r/o | character string | Software version | |
| scon | character string | SNMP system contact | ||
| snam | character string | SNMP system name | ||
| sloc | character string | SNMP system location | ||
| rcom | character string | SNMP read community | ||
| wcom | character string | SNMP write community | ||
| tcom | character string | SNMP trap community | ||
| autr | DISABLED,ENABLED | SNMP traps enabled, disabled | ||
| ipt1..4 | character string | SNMP Trap destination address | ||
| stim | character string | Set the actual time in the following format 'yyyy-mm-dd hh:mm:ss' |
||
| time | r/o | character string | Get the actual time in the following format 'yyyy-mm-dd hh:mm:ss' |
|
| lsyn | r/o | character string | Last time synchronization | |
| ntp1..2 | character string | NTP server IP address | ||
| ivpr | r/o | character string | Invalid parameter value, set only if the entered value out of range |