This chapter gives a short overview about some configuration parameters you want to set after you have installed the sat-nms DEICE-Controller. A complete reference of all available setup parameters is given in chapter 3.4 Installation Parameters .
Photomos-relay digital outputs
In the standard configuration of the sat-nms DEICE-Controller this outputs will be controlled as standard outputs therefore the configuration jumpers are in the upper position (pin 1-2). In the picture below you can see where to find these Jumpers on the PCB of the sat-nms DEICE-Controller. Dont't exceed the continuous current limit of 130mA and the continuous voltage of 48V DC. Otherwise the sat-nms DEICE-Controller might be damaged. If you want to switch inductive loads, don`t forget to add a clamp diode to limit the spike voltages in the switching moment.