This chapter gives a short overview about some configuration parameters you want to set after you have installed the sat-nms L-Band Switch Matrix. A complete reference of all available setup parameters is given in chapter General Setup .
Number of the outputs/inputs
To let the L-Band Switch Matrix know the amount of inputs and outputs, you have to write the corresponding values here. These parameters are set in the delivery state to the correct values.
Switch parameters
The 'Switch' page shows you the souces of the RF-outputs. If you want to change a connection, choose the line of the output which source you want to change. Click on the displayed souce and choose the connection that you like to have. After clicking the "SUBMIT"-Button, the conncetion changes to the desired input.
It is possible to switch an input to more than one output without any Signal loss.