The page 'Config' contains the operational parameters. Operational parameters are those which are assumed to be changed more frequently than the installation parameters on the Setup page.
The page displays a table with the parameters actually set. Each parameter value is a hyper-link to a separate page which lets you change this parameter. This parameter change page shows the actual parameter setting either in an entry field or in a drop down box. You may change the parameter to the desired value and then click to the 'Submit' button to pass the changed value to the LFTX/RX. The receiver automatically returns to the settings page when the parameter has been changed.
To cancel a parameter modification you already started, either use the 'Back' button of you web browser or click to the 'Config' button on navigation bar. Both returns to the config page without changing the parameter you edited.
You have to change the parameters for every Slot.
ATTENTION! If you use 2 sat-nms LFTX/RX chassis in master/slave mode, you have at first to configure and establish the connection between the master and the slave chassis. Otherwise all settings in the slave chassis will be over-written on accomplishing the master/slave communication for the first time. The slave chassis will be configured automatically by the master in order to ensure correct redundancy-switch function. for further information, please refer to General Setup .
At first you have to set the parameter "Card". Choice "NONE" if no card is placed, "RX" if a LFRX card is placed or "TX" if a LFTX card is placed in the corresponding slot.